SIES 2018

13th International Symposium on Industrial Embedded Systems


June 06 – 08, 2018, Graz, Austria, ICT for a Dependable Internet of Things

2nd Symposium on Dependable Internet of Things


05 June 2018, Graz, Austria

Guidelines for preparing submissions

 

Regular Session Submissions

The conference seeks original submissions which were not published yet elsewhere. In order for a paper to be accepted, and subsequently included in the IEEE eXplore paper base, they need to meet certain requirements.

The papers are expected to report on novel developments, not published yet elsewhere, with a prospect for a tangible impact on the research area and, hopefully, a potential for practical implementations.

The need for the work done has to be established: why important, and who is going to benefit from it. It is important that the work is put in the framework of the works published by others, if relevant – outlining the differences, novelty, and arising benefits.

The clarity of the material presentation is very important for others to understand and appreciate the presented developments and results.

Submissions lacking proper validation of the results will not be accepted.

The submission page limit may pose problems for authors reporting on a substantial body of works/results. Authors are encouraged to post that material on their personal pages and provide a link. That should include details of the validation methods/procedures, statistical assessment of the results, etc – anything which would allow to establish validity of the presented results, even to the point of the replication the "experiments".

 

Work-in-Progress Submissions

Work-in-Progress papers describe research that has not yet produced results required for a regular paper, but due to novelty and potential impact deserves to be shared with the community at an early stage. Accepted WIP papers will be published in the conference proceedings.

Contributors will be asked to give a short presentation of their work and to prepare a poster for the discussion forum that will be held after presentations.

The work in progress submissions need to follow the guidelines for the regular and special session submissions. The main difference is the presented work and arising results are initial/preliminary.

Submissions presenting ideas only, without supporting results, will not be accepted.

 

Posters

Along with full research papers, SIES 2018 solicits submissions of poster abstracts whose contribution will be publicly presented during the conference. The poster session will provide a forum for researchers to present their work in progress and to receive feedback from experts attending the conference.

The areas of interest for poster abstracts are the same as for full research papers.

Plagiarism and infringement

Accepted papers are going to be included in the IEEE eXplore data base. That mandates the authors prepare their submissions observing the IEEE policies with respect to plagiarism, including self-plagiarism.

For details, please see IEEE plagiarism policies:

Identifying Plagiarism

A Plagiarism FAQ

Please note that all papers submitted are going to be checked for plagiarism using IEEE automatic tools.

Papers which fail the check will NOT be considered for acceptance, and reported to IEEE Intellectual Property Rights office.

Using material published by other authors

Any material published by other authors cited verbatim needs to be properly acknowledged. The recommended practice is to use quotation marks to embed the cited material, to be followed to the reference pointing to the original publication.

No-show policy

The SIES 2018 Organizing Committee reserves the right to exclude a paper from distribution after the conference at IEEE Xplore if the paper is not presented at the conference.

Submission Link

Paper Submission


Important Dates

Regular Papers

Paper Submission

March 11, 2018 (extended, hard)

Notification

April 9, 2018

Camera Ready

May 4, 2018

Work-in-Progress Papers and Posters

Paper Submission

April 18, 2018 (extended, hard)

Notification

April 26, 2018

Camera Ready

May 4, 2018